hope notandz327 wrote:as long as its not pressure plate to strong for the smaller engine and moving the crankshaft on its thrust washer /bearing caps (excessive end float)causing flywheel to rub somewhere
Moderator: Luke
hope notandz327 wrote:as long as its not pressure plate to strong for the smaller engine and moving the crankshaft on its thrust washer /bearing caps (excessive end float)causing flywheel to rub somewhere
it's ok - it's not that, the noise was there when even a light amount of pressure was applied to the clutch if it was the crank moving it would only be apparent when the clutch was fully depressedandz327 wrote:Didn't mean to chuck a spanner in the works
Luke wrote:not brand new - good 2nd hand - had it off since the noise - no signs of wear and looks mint - same as clutch release bearing
also no judder when setting off either
i'll try but i dont think it will beandz327 wrote:Luke wrote:not brand new - good 2nd hand - had it off since the noise - no signs of wear and looks mint - same as clutch release bearing
also no judder when setting off either
If you put bit of pressure on your gear stick as if to put into gear but not quite then do the action that makes the noise, is the noise different when you try this??
Return to Customising and one offs
Users browsing this forum: No registered users
This site contains affiliate links for which we may be compensated.