G Day all again,
As i have said on another post i am buying a VCM 2 Multi-Language Diagnostic Tools VCM II IDS V86 Diag Scan. When it arrives or hell freezes over
What i would like to do is de tune VM's i am buying 12 seater VM buses taking all the seats out to fit wheelchairs. With less weigh 1st gear has to much pulling power, the rev's come up quick and when u change into second gear u get a jurking motion
( no i cant start off in second gear as it is to high and would need to ride clutch not good )
Corect me if im wrong as ive just been into cars with a PCU for a few months.
With the scaner what i would like to do is change the maping in the CPU so the power comes on at half rate just in first gear with same revs, I am gessing that the speed sensor might control that and after say 30 km could go back to full power, Am i on the right track in my thinking?
Or is there a better way to get what i want
Ron