If this is posted in the wrong place , please move the thread.
I have a Eberspacher DL3C and I am now getting error 64
064 Open circuit - flame sensor Sensor is sensing value outside of range
I suspect I have some bad wiring going to the sensor as I can see electrical tape on a wire going into the case.
Has anyone undertaken a replacement or refurb of the flame sensor. http://www.espar.com/documents/D3LCc.pdf it looks quiet straight forward here.
The plastic rivots are .50p each and I was thinking of just replacing these with some self tapper screws. Anyone know of a good reason why this isnt fine?