Mk7 running rough juddering

[andz327]

Is it still not starting

[Spicerronnie1989]

Is it still not starting

No still not starting in pices checking timeing

[andz327]

Be sure the flywheel pin is in the right slot as there's plenty of slots your pin can go in if its not the proper pin

[Spicerronnie1989]

Be sure the flywheel pin is in the right slot as there's plenty of slots your pin can go in if its not the proper pin

Would the engine run if I was in the wrong hole in flywheel flywheel

[martynx]

Maybe no fuel is getting to the injectors ? Fill up fuel filter , crank for 20 seconds , refill fuel filter..& repeat a few times should help purge or rule out air in the injection system..you could undo feed pipes to injectors , at the injectors, also while you do it then you'll see if fuel is getting there or not... if that doesn't get fuel flowing connecting a pipe directly to the pump & pouring a bit in there works sometimes..

[andz327]

Maybe no fuel is getting to the injectors ? Fill up fuel filter , crank for 20 seconds , refill fuel filter..& repeat a few times should help purge or rule out air in the injection system..you could undo feed pipes to injectors , at the injectors, also while you do it then you'll see if fuel is getting there or not... if that doesn't get fuel flowing connecting a pipe directly to the pump & pouring a bit in there works sometimes..

I think he's had it started with easy start but it will only idle and wont rev up

[martynx]

Cool..I've no idea then;)

[andz327]

But I could be wrong, I've lost the place with this one so dread to think how Ronnie feals

[Spicerronnie1989]

But I could be wrong, I've lost the place with this one so dread to think how Ronnie feals

Well rev up but lots of White smoke and running lumpy got a pic befor I take chain off agen so u all can see timing

[andz327]

Does it start off the key now?

[Spicerronnie1989]

Does it start off the key now?

No mate don't sart of
The key

[andz327]

Timing looks OK as much as I can tell without being there even tho your coloured links arent on the cam sprocket marks
Hsve you got it built back up yet?

[andz327]

Any joy Ronnie?

[Spicerronnie1989]

Any joy Ronnie?

Hello mate had a brack form it put most of it back together tonight but think I now why it wold not start I think the injectors are in wrong wild it stop it starting

[andz327]

It gives you problems, each injector is basically set by computer on that particular cylinder, also the last fault sounds like the flywheel sensor not far enough in that it wont start on its own