Hi guys.
Just bought a mk7 transit and the speedo won’t register. I got a screen shot of what’s wrong if anyone could shed some light.
Thanks
Malcolm
Moderator: Luke
knobby1 wrote:Speedo is driven by the ABS rings on the Mk7. Check all the looms on each wheel.
Have you had the codes read..??
Lord Knobrot
Malcforrest wrote:knobby1 wrote:Speedo is driven by the ABS rings on the Mk7. Check all the looms on each wheel.
Have you had the codes read..??
Lord Knobrot
Checked all the abs sensors and cleaned the connections. Still no joy.
I’m getting an injector coded tomorrow, is it likely they’ll be able to read any fault code from it?
knobby1 wrote:Malcforrest wrote:knobby1 wrote:Speedo is driven by the ABS rings on the Mk7. Check all the looms on each wheel.
Have you had the codes read..??
Lord Knobrot
Checked all the abs sensors and cleaned the connections. Still no joy.
I’m getting an injector coded tomorrow, is it likely they’ll be able to read any fault code from it?
Yep...if there's a code, they should be able to pick it up....do you have a light on the dash..?? If the ABS system was playing up it should at least throw a fault code of some sort....not sure if there's a fuse for the speedo.
Lord Knobrot
Malcforrest wrote:It isn't showing a fault light but today I had someone read the ecu and the following codes were logged:
Vehicle Speed CAN signal (ATT)
Water in fuel sensor circuit range or performance (ATT)
Right Rear Wheel sensor (ATT)
Invalid data Received from ECM/PCM A (ATT)
Would you know what these faults are in reference to?
Thanks again Malcolm
Return to Technical Problems & Questions
Users browsing this forum: Majestic-12 [Bot]
This site contains affiliate links for which we may be compensated.