Loots Red custom

[ake]

Put the 45 pounds injector into cylinder 2 and coded it in, where's woody gone? There's no singular knocking evident, still a gruff when you accelerate but really different now.

Will have to leave it there till morning when the engine is cold, haven't done any resets or anything but it sounds promising, what next tho? Put number 2 back in then back to ford, hey Pedro check all 4 injectors and replace any fooked ones?

You could try, when you book it in, ask if the technician can accompany you on a test drive, then you can bend his ear!

[bigjohnthomas]

i would take it to the dealer and tell them that you have had allcock from allcock,allcock and allcock vehicle engineers listen to it and he said that without a shadow of doubt the number 2 injector making the noise. and ask them what are they gona f*** do about it

[loot]

Shopping trolley

[bigjohnthomas]

Owwww whacha going to put up there ?

[loot]

Nothing probably lol but i love the look of them, even tho these aren't what i ordered
Bloody eBay trades descriptions

1 thing off the list tho

[Punto443]

Looky looky

The guy removed it from his brand new custom limited, all fixings and the original panels too

[loot]

Sweet
How come he took it all out? Camper conversion?

[ned]

He was probably searching for the woodpecker N

[Punto443]

He put a bed in the back, turning it into a day van/ camper thing

[Punto443]

Having to build a shed to store it!

[loot]

[loot]

Used a hair dryer in the 240v outlet with the engine running to heat up the hilti vinyl on the roof and remove it makes a hell of a difference with it hot, cold and it just shatters, got and it came off in large pieces, had to partially lie with 1 leg along the roof and the other on the Hilti chair in the side. Lucky i had the pram rails to hold.
Bit annoyed because the rear rubber bung has had a sharp blade around it to install the vinyl and there is brown there which I'm going to lacquer over once i clean it.

Found some turtle wax compound in the garage new in the tub, might have a little look see

My invertor is only 1000w so no abuse it cuts off

[loot]

Found my inverter.

https://www.portablepowertech.com/produ ... -inverter/

Bit of a conundrum, my mini compressor is 1.100w so it runs then cuts out after 30s because the inverter is 1000w, i can buy a medical compressor which is much less w or i can buy a higher output inverter, bit then the rest of the power al system may not cope, i assume it is all scientifically and mathematically paired up? Probably best get the smaller compressor

Tbh how many times will i need to blow things up?

[loot]

Waited it and used mer but didn't get far because it was drying to quick, still some residue on the bottom of the doors, don't really want to cut the paint but might have to

Cleaned inside and used wipes on the plastics and more wipes on the glass, spanking

[loot]

Blew it out, those start covers are bad for dog hair, they are thick material that doesn't look porous but by god 110psi and it still takes ages to get the hairs out

Also removed the door panel for my little mirror modification but I'm having a coffee and looking at diagrams I'll go back out in a bit, wish me luck in that i don't fook the modules up

(Non serviceable relay?) Who you talking to?