I didn't do it, and it was yesterday I photographed it, but here's how the rear end is coming along.
1. In the foreground, you can see the work in progress. He's patching over a table hole that was put in for the original table mount (The current one is further towards the front of the van). In the background you can see the replacement section of floor and replacement wheel arch he fabricated based on the remnants of the old one. That's not just patched on top of the old floor ... the old floor has been removed.
20170422_113652.jpg
2.Plate on the other side, including reinforcing bars, and patches to the wheel arch on that side ...
20170422_113659.jpg
3. From the back looking in. The centre panel at the back is also needing replaced, that's next to get done. And I asked if I can get the bumper straightened out too. Reversed it into a bollard
20170422_113715.jpg
Large amount of work, but he's doing a good job!
Not shown in these photos is the front ... complete new floorplan welded over top of what was left of the old, both steps reconstructed, new sills.
You do not have the required permissions to view the files attached to this post.