Hi lads just used the forscan software on my transit 2.4 engine.
i have had two codes come up as you can see below, it says fuel timing error which i have heard of before but what is all the other stuff below it mean? as i havent replaced or removed the fuel pump nor do i nave air in the fuel lines.
these are the codes
===PCM DTC P0149===
Code: P0149 - Fuel timing error reported by FIP
Module: Powertrain Control Module
Diagnostic Trouble Code details
Fuel timing error reported by FIP
This DTC may be caused by :
Static pump timing incorrectly set after a pump replacement.
For additional information refer to:
TSB Number
8/2004
If DTC P1564 is present and the engine is knocking, renew the FIP timing solenoid.
For additional information refer to:
TSB Number
64/2004
For further diagnostic information refer to the appropriate section of eTIS.
Air in the fuel system
Blocked kinked or crushed fuel lines
Outlet fuel connector pressure control valve seized or blocked.
Blocked external filter
CPS circuit fault
FIP supply voltage
CPS
===END PCM DTC P0149===
===PCM DTC P1564===
Code: P1564 - FIP requesting reduced fuelling mode
Module: Powertrain Control Module
Diagnostic Trouble Code details
FIP requesting reduced fuelling mode
The FIP has identified a fault that may cause damage to the engine
If any other DTCs are present address these first.
===END PCM DTC P1564===