by stevo » Fri Oct 31, 2014 6:42 pm
Well today I have aquired a parking sensor switch from pete at the transit center, top man. Turns out I have the loom and when I plug the switch in it actually lights up but obviously doesn't do anything without the sensors. My question is, where will the end of the loom be tucked up? The sensor end. I've had a look in the back of the van, have found two connectors, one above the side loading door and the other on the drivers side near the very rear. Has anyone retro fitted them using the original wiring?
Formely ibanez2005
Your's is the new Ford Transit!
2003 100 T260 TDDi swb