transit mk6 rear brake disc conversion

[jay]

that sounds a good idea might get the lot a bit cheaper from a breakers then....both hubs and cables..was going to fit new flexi hoses and replace my rear metal pipe as one on the van so i will have good brakes..
are mk7 front brakes any bigger than mk6? as thats another possibe as well or will just fit grooved and drilled discs when i get to that

[jay]

Managed to win a rear axle for £150 80 miles away and comes with springs and handbrake cables.basically its a undo my old springs and roll springs and axle out then roll in new axle and bolt in place... replacement axle is in good condition as well..

[bigyellow]

can this be done to a transit van 350 with rear drive axle or is it not posible??

[stephenferguson]

Done this to mine a couple of years ago, there may be a pic of what i done with the abs in my signature link below...

I had to spot weld the mk6 abs rings on the back of the mk7 disc if i remember right, and adapted the mk6 sensors to fit the hub,,, worked first time too.

[stephenferguson]

Here

[bigyellow]

so apart from the electrics which i dont have i can just bolt on, bolt off a set from a mk7 rears ??