Mk6 bulkhead questions

[PaudieG60]

Just to update this, fitted the bulkhead yesterday with 16mm tech screws.

Was waiting all week for ford to get back to me with a price for all the bits but had to be fitted yesterday.

One thing to note, without the gasket on the bottom, the bulkhead is 3or4 mm lower than it should be.

Not an issue for me but just putting it out there.

Once again this forum has sorted me out, thanks to all who posted!!

[cabrown89]

Hi all, im looking to get a bulkhead for my mk6 swb low roof. I have seen one advertised with a measured height of 1350mm, but upon measuring my hole that seems about 50mm too short.

Did somebody say, that all the bulkheads are the same size between mk6 + mk7, could someone confirm this? Also could someone possibly measure and confirm the dimentions?

Thanks, Craig

Sent from my D5803 using Tapatalk

[PaudieG60]

I have a mk7 bulkhead in my mk6.
I didn't fit the gasket underneath so the holes didn't line up properly but I used self tappers to fix it in place

[Kgnot]

Hey guys i made registration to give you my predicament.
I have ford transit t350 nu62kbj.
And a option to buy ford transit custom bulkhead mk8
I was tolk mk7 fits my van but what about mk8?
The custom ford look like a medium van mine is large but the gap if its uptop is acceptable