Hello all.
I've got a 03 tipper, 2.4 di RWD 90.
I broke down last week and had to get the as out, fuel was low and pulling into the garage the van just cut out, managed to make it to the pump and put £25 in the tank. Tried to start it and there was just clicking from the starter.
The aa came out and tried to bleed it, he could get it to go for a few seconds but then it just died, he read the codes and these came up
.Patrol found the following fault code/s:System : Engine control 2 - 53C / EEC5-2 EDC VP30/VP44P1563 - Injection pump. Error Message : Engine stop.P1664 - Injection pump. Error Message : Faulty operation.P0335 - Crankshaft position sensor. Error Message : Malfunction.
I got recovered back to my unit, I have changed the crankshaft shaft sensor. Still no joy, I tried bleeding file cracked off injectors and as I try and start the van there is a pool of fuel on the top of the engin.
I'm a bit stuck and needing advice on what to do next?
Thanks,
Mark