well i changed my PRV and SCV and started to do a pump learn
while doing it it was aborted, the only reason i can think of was the cylinder head temp line was still red (not hot enough)
so i tried again and all seemed well untill the fuel preasure shot of the scale and the revs dropped but it seemed to settle and it seemed everything was fine, i think i have managed it as it recorded everything and said it was complete
but now when the van it ticking over the revs drop and there is a noise from the engine, im convinced this is the same noise as when the preasure shot of the scale, if you touch the throttle it goes back to normal for a few seconds then does it again
did i do it wrong ?
while doing the pump learn, just when do you click on the "tick" button ??