problems when it rains

[george999]

she's just had a new crankshaft sensor and new cam sensor and new flywheel and batteries.went into limp mode.she fired up with easy start .but would not rev she would idle ok but not rev.rac came out and said it's low pressure valve on top of fuel rail.had her running on and off while waiting for recovery and now she won't start.

it's a jumbo transit 09 plate 2.4

anyone got any idea of what is wrong

[karl]

cam and crank sync

or injectors f***

[george999]

injectors were only done just over a year ago and the crank sensor and cam sensor were only done 2 weeks ago

[bambi mk 1]

When was the fuel filter last changed Did you check the indicator on the filter head

[george999]

started her up earlier and she started fine but won't rev over 2000 rpm if I try to take her over that it's like a misfire and the ---- dashs flicker

[Punto443]

Low fuel pressure! the rac mans already said!

Probably blown it’s prv!


Might need, scv,prv, pump&pilot learns, updates?
Probably best check the frp and do a leak off test.

[Ml Autos]

Low fuel pressure and low tyre pressure are exact same untill we see the actuall reading of fuel pressure.
Precision guess work)))
What are the fault codes?
What is actuall fuel pressure?
Is tha air gap correct between the flywheel and the crankshaft position sensor?
Answer those and the van will start and run again
Regards

[bambi mk 1]

Is tha air gap correct between the flywheel and the crankshaft position sensor?

Regards

I wonder is the new sensor tight A loose sensor will cause the dash flicker

[Ml Autos]

Dash flickers as rpm drop low

[george999]

just started the transit up and she's running fine .the only thing I can think of is it gets damp when rains hard .

[george999]

after all the trouble over the weekend , went to start her up and she runs fine , it seems everytime it rains it causes her to lose power and she has to be recovered something getting damp and causing a short ????