won't start

[hotrodharley]

just put a used engine in my 2010 transit connect..there is a little black box[aboutsize of a relay]that has 2wires.one goes to harness and second one goes to body ground but it is pulled out of little box;;located on top of engine above alternator area..what is this and with ground not hooking up then would this prevent from starting?another thing did was pulled the crank hub off to give me room to get eng out and other back in;;noticed no key-way to put hub back into same location..so does it matter or since it was removed could that not be in correct spot or is that a issue...have checked everything and everything is pluged in tight..

[bungalow bill]

Hi I'm still learning myself but did you use the engine control unit ecu from the new engine ? If not may not connect to the fuel pump ,perhaps that's it ?

[Altransit]

Hi I'm still learning myself but did you use the engine control unit ecu from the new engine ? If not may not connect to the fuel pump ,perhaps that's it ?

Yours is a TDDi Bill, a 2009 Connect has a very different TDCi fuel system

[bungalow bill]

Ah ok al lol

[bungalow bill]

Had a mate who had a connect same sort of thing was air in the system and a faulty injector ... Took a while to sort fuel filter kept half emptying

[bungalow bill]

Probly not recommended but he dragged started it after he changed the injector and all was fine after ,tryed to prime low pressure pump I think he said but nowt till he dragged it ?? Then it started and ran sound after !! But others will say probly not good to drag em to start ...

[paul2012]

just put a used engine in my 2010 transit connect..there is a little black box[aboutsize of a relay]that has 2wires.one goes to harness and second one goes to body ground but it is pulled out of little box;;located on top of engine above alternator area..what is this and with ground not hooking up then would this prevent from starting?another thing did was pulled the crank hub off to give me room to get eng out and other back in;;noticed no key-way to put hub back into same location..so does it matter or since it was removed could that not be in correct spot or is that a issue...have checked everything and everything is pluged in tight..

wrong section should be in the connect section.

Anyway, Post a photo of the part you are referring too.

You can upload photo to photobucket.com & then copy the IMG link & post it here

[ake]

Moved

[Altransit]

viewtopic.php?f=54&t=151441