Full length exhaust

[bigjohnthomas]

Yeah a baboon with a big red arse would be able to bend it eaaly
Stainless tube isn't cheap though so give him a few bananas first to get him in a good mood

[loot]

Yeah a baboon with a big red arse would be able to bend it eaaly
Stainless tube isn't cheap though so give him a few bananas first to get him in a good mood

Limbo spent over 500 for his twin exit job iirc so I'll see what's about

Can get the Ford pipe for 30 pounds is and maybe stick that straight on the back of mine maybe cut the bend off ? That's if you have the same as in my picture plus the pipe goes over the axle and out the back?

[bigjohnthomas]

Looks the same over the axle then it finished about a foot short of the back of the van
Is it not part of the back box though?
I'll have a look when I get back to gay skull

[loot]

Usually original exhaust are all 1 piece but then replacements tend to be sections, probably got fitted before other bits at the factory but there will be cut measurements in bemm or etis but the replacement pipe will be flared to fit.

It's all very technical