This is what i have done with mine but is not easy you have to open headlights.Thequeenscheese wrote:Yeah that's sorta what I'm after, I can get tommy tuck to do me a set I'm sure if I do, I was more concerned with them throwing a warning light up if I swapped them for the black style? I don't mind losing the projector halogen and osram knight breakers have always done me well..
I had to cut them open and strip is from ebay they are indicators as well as side light.But my complete headlight has been upgraded to proper hid bi-xenon projector.Thequeenscheese wrote:That does look mint, where the strip,from?, how easy are these to open up?
Nop.At least i wasn't able to.Thequeenscheese wrote:So do they not split with a heat gun?
Veki007 wrote:This is what i have done with mine but is not easy you have to open headlights.Thequeenscheese wrote:Yeah that's sorta what I'm after, I can get tommy tuck to do me a set I'm sure if I do, I was more concerned with them throwing a warning light up if I swapped them for the black style? I don't mind losing the projector halogen and osram knight breakers have always done me well..
Sent from my SM-G950F using Tapatalk
Hi guys im going on holiday this Saturday so i will grab some time and write how to and what parts i was using.Pocans wrote:Veki007 wrote:This is what i have done with mine but is not easy you have to open headlights.Thequeenscheese wrote:Yeah that's sorta what I'm after, I can get tommy tuck to do me a set I'm sure if I do, I was more concerned with them throwing a warning light up if I swapped them for the black style? I don't mind losing the projector halogen and osram knight breakers have always done me well..
Sent from my SM-G950F using Tapatalk
Yes I too would be interested on how you did your headlamp upgrade.
1. How did you break the seal? With heat gun? Or just left out in the sun with this hot heat we’re having (July 2018)? Or in an oven?
2. Did you key/sand the area to paint with which grit paper?
3. Which primer and paint? Was it UV resistant to last?
4. Which LED strip did you obtain from EBay? Does the kit need any additional wiring?
5. How did you reseal the headlamp unit?
I know there’s plenty of videos on YouTube, but always good to learn from experience of others.
Hi sorry for delay in posting but here you go.So headlights have to be open by cutting it just on the edge next to clear lense as they can not be bake opened first they do not fit in any oven, i have put them togethere (glued) first with hot glue gun as it goes off quickly (spot glued) then i have completely sealed with Black ct1 https://www.toolguru.co.uk/ct1-sealant-black and is very strong bond and it lòoks ok.Pocans wrote:Any luck and listing out materials/paint used?
Users browsing this forum: No registered users
This site contains affiliate links for which we may be compensated.