Alloy Wheel Adaptors??

[Luke]

The wheels and tyre both have to have a load rating up to or exceeding the axle load. Thats the law whether you are using the vehicle commerically or not

correct but most wheels dont have a load rating on them - my wellers dont i would advise using a bit of common sense if an alloy looks weak it proberbly wont be suitable

[Luke]

we use them for racing...transit stud pattern,(Some use a morris LD pattern) but between 8" and 14" wide usually lol.

5 or 6 stud

[speedy]

we use them for racing...transit stud pattern,(Some use a morris LD pattern) but between 8" and 14" wide usually lol.

5 or 6 stud

6 stud....they do 5 stud I think but nobody uses them now. Also my mate imports a weller copy, which should be available in transit pattern soon.

[Luke]

i take it it's stock car racing have you got any pics of the wheels

[speedy]

Cant seem to find any pics in the tranny pattern, but the design is the same. The ones above left are what my mate imports,like a weller but bigger holes. The one on the right he makes himself.

Below is a car with the wellers on...again not transit pattern i dont think (LD?) but they do them!!

[Luke]

the 14" wide ones would be cool but i doubt you'd get a road tyre to fit