Cosworth boa manaul box

[rob hall]

Hi having trouble getting the flywheel 2 fit, I bought the pinto adaptor plate ,flywheel and starter off ebay,butt the holes dont match on v6 ,so I bought a xr4i flywheel but the diamater is too small so the ring gear dont reach the starter! Ive go a mt75 van box, need help asap as project is on stop till I sort it!

[trigger]

You need the adaptor plate off a Transit V6 Ambulance

[AndyJ2506]

can't you redrill the one you have to fit the v6

[rob hall]

No , I dont think theres enough room due to the hole in the middle

[rob hall]

What if I welded the old holes up and then redri?ll it? Has any 1 done this?

[Luke]

people have done it with the pinto plate - look up guy88 and oxtonyxo's progress threads on here

[rob hall]

The pinto plate isnt the problem, its the diffrence between the pcds on the v6 and pinto flywheel

[trigger]

You need a V6 flywheel then

[Luke]

The pinto plate isnt the problem, its the diffrence between the pcds on the v6 and pinto flywheel

have you looked up the threads theres info as to how it was done on both of them - either redrilled the pinto or used a v6 i cant remember

[rob hall]

Thanks peeps

[rob hall]

Hi progess so far
Adaptor done
spigot bearing done
Pinto flywheel redrilled and fitted
Cluch fitted
Gearbox fitted
But ive notice a problem with my cluch leaver it doesnt have enough travel to engage the cluch/disegage drive,
Has anyone else had this problem?

[BROWNYS V6]

warm the clutch release fork with oxy an give it a bend,had the same problem on a sierra
did the trick

[rob hall]

Fixed it
I got a old cluch arm cut the middle section out and welded it onto my exsisting 1
And also fitted the manifolds.

[AlanN]

any pictures Rob

[rob hall]

Will try and get some up tomoz