transit mk6 indicator problem

[landytechsheffield]

hi guys and girls so i have a mk6 2.4 long wheel base crew cab recovery truck
right the problem is the left indicator will not work iv put a new stalk new relay all fuses are fine new hazzard switch all indicators work with hazzards on any idea what im missing or as any one got a wirring diagram off the indicators
cheers

[Frag]

Have a look under bonnet on inner wing,under the coolant header tank for a plastic box with relays in.
These are for indicators each side and can get water / corrosion which will cause the problem you have..

[landytechsheffield]

yes pal and there ok

[Frag]

Try swapping those relays around (make sure but I think they are all same in that relay box)
Take it off its bracket and turn it over,I’ve seen the wires break off underneath from dirt and water thrown through inner wing.
I’m sure your problem will be in this area,if all your lamps work with hazards,that’s ruled out wiring and lamps.
There’s a relay for each side indicator/s in that box,so 1 for all right hand,1 for all left hand indicators.

[scas]

usually if the hazzards work then its the relay under the dash , near the steering wheel. did you change it for a genuine one as the aftermarket ones never work on a mk6

[joarnes]

I had the same problem. In my case it was the relay or relay-looking thing who I found under the plastic cover in the left side footwell/footstep. It was spools inside this relay with kind of breaker-points, sanded little between the points and problem fixed. My Transit has the steering wheel on the left side so maybe this relay thing is at the right side on UK cars?