24V Cossy V6 advice needed

[trigger]

I need to know how much of the wiring loom i actually need to make the engine run, i have the bit that goes into the ECU and the bit that feeds the coil pack, there was so much wiring in the car i took as much as i could but i don't think i have all of it, there are so many sensors that i don't think i have the wiring for, the haynes book i was given with the engine only covers 1.8, 2.0 and 2.8 not 2.9 cosworth, i know a few people have fitted these to Transits how much wiring did you use? also do i need the EGR? if not i will remove it, does anyone have a wiring diagram for the cossy and could they post it on here? any help would be most apprieciated

[madmark_50484]

Easy put carbs on it and do away with the injection system.

[trigger]

Easy put carbs on it and do away with the injection system.

Sort of defeats the object really, if i was going to do that i would have got an Essex V6

[madmark_50484]

does that seriously decrease the performance of them then ?

[bazw]

not if you spend a few thou for a manual ignition system to be custom made , custom inlets as it was never made with carbs ,oh and a good few hundred squid on a bunch of carbs

lol

[bikemad]

go on ebay there is a bloke on there who sells cosworth manual on cd. think £3.99 i had one its got all the diagrams you need.

[trigger]

go on ebay there is a bloke on there who sells cosworth manual on cd. think £3.99 i had one its got all the diagrams you need.

Thanks bikemad, i will have a look for that

[AlanN]

Have a quick look here first
http://www.siipicossu.com/

[trigger]

What section am i looking for Alan? can't understand cos it's not in English

[AlanN]

Sorry trigger, looks like they have deleted all the wiring diagrams, might have been asked to by Ford, shame

[Guy88]

you need the whole engine loom really, then remove the auto bits and air con depending

[trigger]

you need the whole engine loom really, then remove the auto bits and air con depending

Car didn't have air con (well there is no compressor) i'm using a manual box so don't need the gearbox part, i think i have got most of it, what i haven't got i will have to make up, another question is do i need the EGR, can i blank it off or remove it like on the Transit engines?