prop shaft bearings

[snowballer]

Here goes my first job on my minibus,just ordered my bearings hope there the right ones lol.30mm.I have a lwb minibus s reg....any ways looked underneath i see the prop is in three parts with two bearing carriers if thats what you call them..
I could do with some detailed instructions pics etc to do the job,where i start the gearbox end or other what to undo first etc i have read a few post i see some nuts are torx what size will these be thanks any help much appreciated newby to the smiley

[snowballer]

Well thanks for the help,sussed myself,only problems encountered was that the bearings at the front couldn't remove.Due to torx screw been rounded off by someone, luckily for me the rear ones were the fault so replaced them.The main problem was getting the bearings off the shaft not really simple,in the had to cut through them with angle grinder laid on the floor not advisable sparks everywhere lol everything else went ok..