Rob Cee's transit - start of makeover

[robbie.cee]

The headliner will make it warmer as well at night, mine you a few beers help as well.

debating wether or not to cut hole in roof lining so the roof vent can suck air out of cabin, or leave it extracting air from between roof and roof liner??

ideas guys?

[limitedblack]

Is it one of those rotating gizmos?

[robbie.cee]

yup sure is, sorted my condensation issue so its staying! just need to decide if to stab hole in roof lining or not so it pulls from passenger area or not?

probably will end up doing it and fitting a small speaker grill over hole inside to tidy it up a bit ?

[limitedblack]

Sounds like a goer, fingers ok now ??

[mealic]

yup sure is, sorted my condensation issue so its staying! just need to decide if to stab hole in roof lining or not so it pulls from passenger area or not?

probably will end up doing it and fitting a small speaker grill over hole inside to tidy it up a bit ?

Try looking at tlc-direct .co.uk Many vent covers on there and you could always "rattle can"`em.Think I`ve got a couple anyhow if you can wait` til Mania

[robbie.cee]

Cheers Ali reckon a 5.25 inch,one or similar diameter would be fine!

Off to the plumbing shop tomo to get me a 10mm compression fitting
Gonna get this Pas sorted once and for all...

Then that fooking rattle coming from under van when warm....

Then pull plates off exhaust manifolds and re bore em...
Had a brainwave that theyre likely restricting The Essex from flowing properly...

That's my excuse for poor runs at weald this year!

[robbie.cee]

So here s those pix i been promising...

New roof lining in rear area cheers Minor Matt



BTW the CB stayed put but thats also cos launches off the line wasn't so good this year




trailers???? this may be useful sorry poor pix



thats all folks

[limitedblack]

Gonna get this Pas sorted once and for all...

Haven't you done that yet


Sent from my iPod touch using Tapatalk 2

[robbie.cee]

Gonna get this Pas sorted once and for all...

Haven't you done that yet


Sent from my iPod touch using Tapatalk 2

ERRRRRR , No! too busy to even sh*t then when i get time its friggin pitch dark! remember me pissed up on the sat night pulling the pump out cos it was the only "emma n aaron" free time!!!

fek soldering etc a few guys now have said go compression fitting route so thats what ill try first!




typed by hand on a sh*t laptop i got for free from carphone warehouse

[robbie.cee]

Sweet. Pas pump plumbed in. Just need to secure pump and wire it up!
Pix soon!

[limitedblack]

Sweet. Pas pump plumbed in. Just need to secure pump and wire it up!
Pix soon!

So finish about September then


Sent from my iPod touch using Tapatalk 2

[robbie.cee]

Just got to connect trigger wire from alternator to relay, fill with ATF fluid then.check for leaks and test !
I will fit switch to interrupt relay at later date. Have run pump from second battery too cos it was nearest battery!

[limitedblack]

So as I said, September then


Sent from my iPod touch using Tapatalk 2

[robbie.cee]

All done, well can't find the fluid do ill buy more tomo then test it out and check for leaks!

[limitedblack]

Then give your shoulders a well deserved rest.


Sent from my iPod touch using Tapatalk 2