Punto's mk7

[Airthies]

The kids still have small feet

Perfect size for poking a toe through the front!
Not sure how carefully yours are but I'd need some serious mesh in front of it if my boys were any where near there! Looks good though.

[Tango330]

Were there already holes to take your SVO box under the dash Mr P Mine doesn't seem to have anything at the right height to bolt it to, might have to make a bracket

Also, is there a handy connection point for the ign and perm lives or did you just tap in somewhere

sorry for the beginners questions

[Punto443]

I stripped the SVO out the scrapper, so I got the bracket to mount it to the original dash board bracket and had the wiring too.

Permanent live was run from the customer connection point at the seat base and the ign live splices into the heater wiring loom.

All the details are in the BEMM if you want more details

[Tango330]

I stripped the SVO out the scrapper, so I got the bracket to mount it to the original dash board bracket and had the wiring too.

Permanent live was run from the customer connection point at the seat base and the ign live splices into the heater wiring loom.

All the details are in the BEMM if you want more details

Cheers Mr P

[Punto443]

Time for another wee update

So.......

Finally found a PAM, wired up and new bumper for the sensors

[Punto443]

Added in a new control unit for my lights

[soprano1982]

Nice mod - how does the pam work ? What is it wired to

[Punto443]

I never had the wiring, so had to add it, If it's there, two plugs for the PAM behind the speedo, plus a little one for the sounder and six wires running front to back for the sensors

[soprano1982]

I doubt mine would have it was lx spec - but I'm gonna look haha , you planing a how too

[Punto443]

Funnily enough, the earlier vans seemed to have more wiring than the newer ones? I pulled the loom out a 07/08.

I don't know what age yours is?

Mine had heehaw! Nothing for heated seat, aux power, PAM, alarm It's a 2011 trend

Never even had the rear speaker wiring!

[soprano1982]

Mines a 56 plate - it had the right bcm to add cruise, (oh and you were spot on with the reg plate lamps was a bad earth)

[Punto443]

Well, I actually done some work that needed done

Front discs and pads

image.jpeg

[Punto443]

Forgot, I done the rears too

[Tango330]

So how difficult was it then Mr P

Did you use ford parts Was it really pricey

Is RWD harder or easier

Sorry for all the questions

[Punto443]

Wasn't hard at all dude, rwd rears I believe harder and it was only £236 for all 4 discs and pads from ford, so just bought genuine