by camper extraudinair » Fri May 31, 2019 8:03 pm
Hi Transiteers i'm back after about five years ?, i have at last resumed work on
my mk1 Transit landliner, i did a thread on it years ago that some of you might
remember, i have just flared the front wheel arches as the mot tester mention
ed that the larger wheels & tyres were very close & possibly touched on the od
occasion, so with the aid of a club hammer & a heavy block of steel i proceded
to bash f--k out of the wheel arches & then using a lighter flat hammer & dolly
to finish off the final curves, i then got a length of stainless steel bundy piping
cut a slot in it, & bashed it over the sharp edges of the wings, i then welded it
on & proceeded to fill & sand them till they looked like a reasonable job as pi
cs will show, adding the piping stiffened the wings & gave them the strength
i had taken away by doing away with the angles, will give more updates as
i progress, happy Transiteering.
You do not have the required permissions to view the files attached to this post.