


so i started cutting the tin worm out after many hrs of deciding wether or not to scrap her but theres not a lot out there i can afford and what would i end up with
after 4hrs of string the inside of me camper



so at this pont i replaced the out riger and lower out side inner wheel arch then repaired the inside

all done on that side but then i relised the weel arch was 50mm further out than the other side so pulled it back in line with a rachet srap an this happend

so plated it up
in progresss with filler
then whilst i had the towbar off i made 2yrs ago i thought id put me new 1 on with a t bar style step i made from a road form/shutter that looked like this to begin with
but 3m longer

and after a lot of cutting and messing about looks like this

then this is me old tow bar with legs

to this

so thats that all done now apart from painting it again. like i say i did consider scraping her but its my van and i love her
thanks for looking





