my new toy is here .... updated as I go

[dodgy01]

after some searching i have found a new toy
well it is a 2004 100ps 260
just under 100,000 miles so not to bad
the nice thing is that it gas the full electric pack .e windows ,anti skid , front spots , heated screen , heated and elec mirrors
so i am well chuffed
i paid 1,950 for it
what do you think







Build Date: 30.04.2004
Vehicle Line: Transit 2000
Cab Style: Regular Cargo Van LCF
Series: 260S Series
Engine: Duratorq DI 2.0 (100PS)
Transmission: 5-Speed Manual Transaxle - VXT75
Drive: RHD FWD
Axle Ratio: 4.23
Emission: Light Duty Truck Stage III
Territory: (+)"GB"
Paint: Colorado Red
Interior Fabric: Stylize (-G-C)


i ripped out all the racking and i will start to sort out the paint and few rust spots tomorrow

[Boo-radley]

Looks a bargain Dodge..

[transitandy]

very nice and looking forward to the thread on the painting

[m99abe]

Sweet, wish mine had electric pack , looks mint on pics

[dodgy01]

its far from mint
but i happen to have a spare 3 litres of gun metal grey metalic paint
mmmm now what could we do with this

[m99abe]

Set about it with a da and squirt it!!!! I love dark greys and anthricites!!! 3 litres?? will that be enough, may be black it first tho you dont want the red humping through

[alcapone]

Gun metal will look cool!

[Brains_transit]

Nice choice and spec

[g-man]

gunmetal then a set of allys

[dodgy01]

well a bit of a update
ive been a little busy today










well its ready for paint on monday

job done

[ake]

You're not hanging about

[dodgy01]

Sweet, wish mine had electric pack , looks mint on pics

you still think it looks mint

[m99abe]

Mines got primer from a**hole to breakfast time to cover my rotten bits and dings!!! Going to try and get some more done to mine next week!!! Yours looking Breyer already, look forward to seeing the results, better than the telly

[transitandy]

A good days work looking forward to seeing it all done m8y

[dodgy01]

well not much done today as we went to a car show in aldershot
well got back at 4 so had a few hours to sort out the floor and managed to fit the seats








all bolted down with some 3 inch square spreader plates made from 4mm steel so they should not go any where