*NOW BOOKED FOR 2026* Transitmania 17 @ Santa Pod 17th to 19th July 2026 *ALL DETAILS HERE*
new seat
Moderator: Luke
19 posts
• Page 2 of 2 • 1, 2
by aki74 » Wed Oct 12, 2005 12:43 pm
I've had my finger under the presser foot a couple of time but luckily havent hit the needle yet. One seamstress here has sewn through her fingernail 
so I try to work slowly enough not to do the same.
so I try to work slowly enough not to do the same.-
aki74 - Transit Addict
- Posts: 90
- Joined: Fri Aug 19, 2005 8:35 am
- Location: Finland/Porvoo
by Gunslinger » Sat Oct 15, 2005 3:44 pm
ah ha .... so thats what an original floor is supposed to look like 
... mine has patches all over the place now 
interesting how much you had to cut out of that to make the box fit, and not the same amount from each side ... you planning your own panels or got a mk3 to cough up the required panel ?
... mine has patches all over the place now
interesting how much you had to cut out of that to make the box fit, and not the same amount from each side ... you planning your own panels or got a mk3 to cough up the required panel ?
-
Gunslinger - Transit Devotee
- Posts: 1720
- Joined: Sun Apr 03, 2005 12:24 pm
- Location: west oxfordshire
by snakemaster » Sat Oct 22, 2005 7:03 pm
I cut a bit more out of each side and then back to the gear box crossmember and used a mk3 bulkhead and a 3" x18" strip to fill in below
the heater and welded it up and now it looks ACE
Transits the best thing since sliced bread
the heater and welded it up and now it looks ACE
Transits the best thing since sliced bread
-
snakemaster - Transit Aficionado
- Posts: 342
- Joined: Sun May 15, 2005 8:13 pm
19 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users