Good day fine forum folks!
Grumbling over my old MK2 bus restoration project.
Had planned to get it into a cramped workspace to get started on some dent removal, turns out I couldn't get it running safely due to the injector pump leaking...
Long story short, I managed to snap the plunger in two whilst dismantling - had to grit my teeth whilst holding back crocodile tears.
Before I go tearing into a neighbours DI 2.5 engine to see if the inline pump will fit my 2.4, is there any chance of procuring the plunger for this Bosch pump that I currently possess?
Appreciate any help.