back doors

[ringneck]

hi me again i have a 1997 100L and have notice that the back doors are not closeing right anymore and was wondering is there a way i can ajust them

[blue stripes]

i am having the same problem doors dont shut properly or do shut properly and then its hard to get them open again tryed adjusting locks but did not make any differance

[ringneck]

it looks like the doors are tight at the top and 2 inch gap at the bottom

[blue stripes]

im not sure a 2 inch gap is possible take it you mean 2 cm sounds like the top hinges need adjusting
if its the same as my van on the inside of the rear pillers there are access holes to get to the hinge nuts losen them off get doors state tighten back up

[GBBiker]

Have the hinges been re-welded at any point or the bodywork around the hinge bases been re-built?

Mine are on the pi$$ due to a botched up re-building on the lower corners by the previous owner - tight at the top and 1.5" gap at the bottom

[ringneck]

no nothing was rebuilt on the van thanks for your help ill try open the hinge