Rear door chequer plate bottoms... again!

[darkbluevanman]

Got 4 sets, 3mm thick in the slightly smaller 3 bar (pic is 5 bar) chequer alloy, as picture (just the bits at the bottom of the doors, NOT the step!) with a 10mm lip that folds under, £23 delivered, first come, 1st served PM me.

[jedmac]

Hi,
Not sure if the first reply got through!!

I would like a set please ,


Cheers

Ed

[darkbluevanman]

Hi,
Not sure if the first reply got through!!

I would like a set please ,


Cheers

Ed

PM sent

[edna]

i will have a set as well

[ZeldaTheWelder]

Hi where did you get the back lights on your van from? they are

[birdy]

And me pm sent.

[darkbluevanman]

Hi where did you get the back lights on your van from? they are

2nd hand, ebay, can't buy new now?... sometimes come up on here...

[darkbluevanman]

1 set left!

[dirtydog]

I'll have that set thanks!

PM sent

[darkbluevanman]

ALL GONE.... Thanks guys.

[darkbluevanman]

Forgot to say.... sikaflex is best (mine are + a couple of rivets) offer the plate upto the door (after you've buzzed of all the scabs!) draw a pencil line along the top of the plate, then place a strip of masking tap just above the pencil line, (drill rivets holes if you wish) sikaflex the door close to the edge/tape and press plate on, smooth goo at top of plate and pull off tape for a neat line... use tape to hold on wilst goo goes off, it's doubtful they'll ever drop off!

[birdy]

Got mine this morning ,cheers pal.

[dirtydog]

Mine turned up yesterday apparently, postie knocked on the door and gave them to the other half ans she put them away for me and then forgot to tell me
Just need to find the time to get them fitted

[oldmadbiker]

where can i get sikaflex from....tried looking for it online but cant find any in milton k..

[darkbluevanman]

Good motor spares shops... maybe local windscreen shop?....... ont' ebay at the mo' some cheap prices ( as it is normally quite expensive!) also known as tiger seal.