When i start my transit mk5 '98, the engine light is on for a few seconds and then turns off. As i understand this means it has errorcodes stored. I would like to tackle this problem.
From what i've read there is only one option to read the codes, which is to put it to a lucas laser 2000 tool to the van. Is this correct or are there other ways to get the codes read?
And what about resetting the errorcodes, are there any options other than a the laser2000 to get this done? Unplugging the battery for a while?
I'm located in Holland, does anyone know a good garage or adress to get the van hooked up?