2.5 di push rods ????

[Mattyone]

I am in need of a couple of push rods for my 2.5 di engine, 2 got bent when the belt slipped. I ordered 2 and was sent the same as the one on the left, but the the one on the right is what came out of my engine. Anyone know why there is a difference and does it matter. Thank you

[V184]

one on right is later version

[cherniy_chack]

Fully interchangeable.

[Mattyone]

Fully interchangeable.

That`s good to hear but can you mix them together

[V184]

Fully interchangeable.

That`s good to hear but can you mix them together

yes

[gotgcoalman]

When you re do the valve clearances the difference is taken up.

Sent from my Plus E using Tapatalk

[cherniy_chack]

Fully interchangeable.

That`s good to hear but can you mix them together

Yes.
I had three or four motors, good and bad.
When repairing the engine, I took any rods, so long as they were not bent and did not have wear on the contact surfaces.