removing passnger seat.

[dragonmous3]

Ok iv got the bits I need but help I can not get the Ford bolts holding the seat in out I have a T50 bit and that seams a loose fit but the next size up is way to big any one got the solution for me please?
I'm fitting a turn base as she will be a camper.

[Brains_transit]

It's a ribe bit m11 but a t55 will work if they're not seized solid. Personally get the ribe m11 if you can but it on its own

[dragonmous3]

Thank you i am leaving SOP WD40 to soak in to assist I will go bit shopping as they are solid

[squirrel93]

Thank you i am leaving SOP WD40 to soak in to assist I will go bit shopping as they are solid

Use a jack pole or a power bar to get them moving

[coacher]

Where are you? I've got one in my van I could lend you.

[BabyDontYurtMe]

I had to use a breaker on 3 of mine when removing the passenger seats, using a T55. It doesnt help that some of the ones I had were rubber coated so the rubber was gripping against the floor so they wouldn't turn. I did the WD40 trick too, helped me out with the stuck fast ones.
But as above, if you have a ribe bit apparently they come out a lot easier...

Good luck!