How to add factory cruise on a mk7 transit no pics

[Tango330]

Deepest Dorset eh, perhaps you're the other 57 plate I've seen about I'm in Corfe, working in Dorch and generally all over the place. Picked mine up in September from eastleigh, did you have to go far for yours?

Yes Mate I do get out that way every now and then. Picked mine up from over Eastleigh way somewhere too, in October. Had a feeling the bloke was selling them for a living when they checked my money with ultraviolet pen
Will try and dig out his address tomorrow so we can compare

Good van so far though, how's yours

[loot]

Yeah changes back

Looks like a drop of lock tight from the steering wheel nut

So what is the point of that then? Maybe for the Continental drivers?
It probably won't work on mine buti might havea go tomorrow, did you figure out where all those wires went?

[Rumble bee]

Yeah sorted now thanks. Noticed it whilst putting the air bag back on the wires were earthing and activating the horn relay

[loot]

Yeah sorted now thanks. Noticed it whilst putting the air bag back on the wires were earthing and activating the horn relay

Oh right, but did yours say drivers door open when you first got it working?
And what were the extra wires for then?

[Rumble bee]

Extra wires were the old horn wires from the old wheel. Yeah mine displays which door is open rather than ajar

[HughF]

Deepest Dorset eh, perhaps you're the other 57 plate I've seen about I'm in Corfe, working in Dorch and generally all over the place. Picked mine up in September from eastleigh, did you have to go far for yours?

Yes Mate I do get out that way every now and then. Picked mine up from over Eastleigh way somewhere too, in October. Had a feeling the bloke was selling them for a living when they checked my money with ultraviolet pen
Will try and dig out his address tomorrow so we can compare

Good van so far though, how's yours

SWS Commercials was where I got mine from, seemed a sound guy. He had a few, I got the one with the best bodywork but higher miles.

Mine has been sweet, needed a SCV+PRV, Martyn sorted that out and It will need a clutch master cylinder, but It really is a superb truck for what I want. Needed a water pump last week, but that can't be helped.

[Tango330]

SWS Commercials was where I got mine from, seemed a sound guy. He had a few, I got the one with the best bodywork but higher miles.

Mine has been sweet, needed a SCV+PRV, Martyn sorted that out and It will need a clutch master cylinder, but It really is a superb truck for what I want. Needed a water pump last week, but that can't be helped.

Ahh, different bloke then. Mine's got a couple of little bits on the bodywork, but still not too bad, and reasonable miles. Just done the SCV and PRV, and off to Martyn this aft to get it pump and piloted. Still well pleased with it though. Will keep an eye out for you next time I'm over that way, and catch up for a brew.

[loot]

Just beeping my horn and ppl looking at me like i have special needs Still says door ajar lol think Chris is on a windup!

[Rumble bee]

Un plug the horn first

Will do a vid for you later

[loot]

Great thanks, i have earlier clocks but it's worth a try

[soprano1982]

Cheers loot - it made sense in the end - really easy switch over
Had to bend a screwdriver to get the airbag off haha

All sorted & ready for Martyn

[mark06]

Cheers loot - it made sense in the end - really easy switch over
Had to bend a screwdriver to get the airbag off haha

All sorted & ready for Martyn

Hi mate

Did you disconnect the battery or just unplug the air bag from under the steering colum

Cheers

Mark

[soprano1982]

I only disconnected the bat once i popped the airbag loose- as I needed to start the engine to
Turn the wheel to get at the clips , once I had it loose I took the negative off and waited 5 mins haha - just incase

[jjo5ner]

mines sometimes comes up door ajar then changes to either drivers, passengers , luggage compartment or rear door open , a boy i know works at am phillip says its just waiting for a signal, doestn often say ajar thou, still waiting on same boy changing my wheelbearing (getting wild now) so i can get dan in glasgow to turn my wheeel on

[mark06]

I only disconnected the bat once i popped the airbag loose- as I needed to start the engine to
Turn the wheel to get at the clips , once I had it loose I took the negative off and waited 5 mins haha - just incase

Thanks for that , better safe than sorry

Mark