power steering pipes info req

[retsof]

hello one of the power steering pipes on my van has rusted through..
i was tying to take it off today and i"m not sure how to remove the pipe from the steering rack end it looks like its all molded as one unit!! is this the case or am i missing something blindingly obvious !!??

any help would be appreciated thank you

its a transit 330 mwb td 90psi semi high top first registered 08 2000

[tranycamperman]

I believe you may be looking at were the steel pipe joins the flexible rubber section?

If so you are right to assume it's all one pipe. So unsrew the pipe from the rack end and follow it up to were ever it goes at the other end

[retsof]

hello again were the pipe joins the rubber section is were its leaking from its were both pipes enter the steering rack i was asking about the bit near the axle...
thanks