Hi guys
I have a Transit mk 7, 2,4TDCi engine and a broken wire harness that runs to the MAF. I have ordered a new connector but are unable to identify which og the four wires are going to each and separate pins on the MAF.
Seem to be one 12V DC cable, one earth based on measuring resistance. One with a few V DC and one unknown. The two later I believed is called MAF sensor signal and signal return. If I am right on this I simply need to know which pin they need to be connected to on the MAF.
Thanks folks.
*NOW BOOKED FOR 2024* Transitmania 15 @ Santa Pod 19th to 21st July 2024 *ALL DETAILS HERE*
How do I identify and match MAF pins with loose wires?
4 posts
• Page 1 of 1
How do I identify and match MAF pins with loose wires?
by JABpilot » Thu Aug 24, 2017 6:34 pm
- JABpilot
- Newbie
- Posts: 1
- Joined: Thu Aug 24, 2017 6:16 pm
Re: How do I identify and match MAF pins with loose wires?
by loot » Sat Aug 26, 2017 10:20 pm
This any good?
C1-3 goes to engine fusebox c3-f28 12v 5A.
C1-3 goes to engine fusebox c3-f28 12v 5A.
You do not have the required permissions to view the files attached to this post.
-
loot - Site Moderator
- Posts: 33490
- Joined: Sat May 05, 2012 6:06 pm
- Location: North Wales
Re: How do I identify and match MAF pins with loose wires?
by robbie.cee » Sun Aug 27, 2017 10:10 am
Maf has 12v and earth then other 2 are a sort of earth based feed and return to ecu.
Sent from my SM-G920F using Tapatalk
Sent from my SM-G920F using Tapatalk
2.9i 24v cosworth v6 LSD now fitted and quad pipes out back
Had
X-Reg Mk5 150ps 3.0 ESSEX V6
MAKE IT FIT
RIP Kirk Bacon aka Eugene Speed
Had
X-Reg Mk5 150ps 3.0 ESSEX V6
MAKE IT FIT
RIP Kirk Bacon aka Eugene Speed
-
robbie.cee - Transit Extremist
- Posts: 9238
- Joined: Sun Oct 31, 2010 6:46 pm
- Location: Basildon, Essex, UK
Re: How do I identify and match MAF pins with loose wires?
by v8dave » Sun Aug 27, 2017 10:42 am
A picture is supposed to be worth a thousand words....
You do not have the required permissions to view the files attached to this post.
mk7 08reg 2.4 T350 LWB MHR RWD
mk6 X reg 2.4 T350 LWB MHR RWD - scrapped
mk4 J reg 2.5 L300 LWB MHR RWD - sold on
Notice a trend there ? not too big and not too small
mk6 X reg 2.4 T350 LWB MHR RWD - scrapped
mk4 J reg 2.5 L300 LWB MHR RWD - sold on
Notice a trend there ? not too big and not too small
-
v8dave - Transit Fanatic
- Posts: 3417
- Joined: Sun Jan 24, 2010 10:23 pm
- Location: Home counties
4 posts
• Page 1 of 1
Return to Mk6 & Mk7 - Third Generation Transits
Who is online
Users browsing this forum: Google [Bot]