Ok, so....
I received my shafts sourced new spring clips, started putting them together and guess What? There not the same as the old ones
paying lots of money and waiting weeks they've messed up the shaft diameters in the middle.
It's not a huge issue in it's self, it may well work ohkaye but it's just not right!
So do I...
build them up and run them anyway?
or
get them to make them properly?
The sections where the cv boot locates is too narrow so gater will be squashed & where it sits is actually too big in length and at one end the spider goes too far onto the shaft.
Bloody hate relying on other people to do jobs and they make an arse of it!
Efity efin effs for efs sake. It's not that hard to copy something is it?
And the other guy making the propshaft apparently never noticed that the weld on one end of the tube is all porous!
My 10yo can weld better than that.
Sent from my anu5 using crapatalk