by Frag » Sun Jun 16, 2019 3:34 pm
If its sticking out proud of the pillar,there are 2 torx bolts through the lower front roller,loosen these and adjust door inwards...
If the gap between door and that pillar is too large,it should also be too narrow at rear edge of door,to move whole of door forwards in its frame,support the rear edge of the door,mark around the centre roller where It sits on door,loosen the mounting bolts to door (TX40 i think) Move the roller towards rear of van,then tighten bolts,this will push door forwards in closed position.