Hi all, new here and hoping I could get some help.
I have a problem with my heaters on a 56 plate 1.8 Connect. Speed setting works ok but only blows cold air. While trying to figure this out today I noticed that although the temp gauge rises to the centre of the dial, it does dip slightly under hard acceleration. Related?
The top pipe from the rad is hot and the bottom one I would say is v.warm. Def not as hot as the top one. I'm assuming that this is the way a rad is supposed to work.
Other thing ive noticed is when turning the heater control from cold to warm and back again I don't notice any change in resistance or any sound differences. Could this be a problem with the heat selector or wiring?
What do you think I should focus on first? I should also probably mention that I'm not a mechanic, I'm an electrician so simple terms would good
Cheers
Dan