blue estate wrote:No , to many jobs in the house to do this weekKenton wrote:Nice one Have you attempted the intercooler yet blue?
May see what time I have later in the week
What sized hole cutter did you use ?
Sent from some where
Sorry Blue, in reference to the hole cutter size, as you can see in one of the pictures I took (drill on floor with stepper cutter fitted) all we did was measure the size of the sensor across the thread, then drill in one or two sizes too small first of all. Then step it up another size until snug. Then wrapped a couple of layers of PTFE. Could not tell you the eventual size, as we didn't check! If you do the same starting from too small and work up one or two, you will get there.
Good luck pal Let me know if you get it done