But hopefully there is now some light at the end of the tunnel.
Van as we bought it




was happy with the van until on the way home when the under storage fell away from one side.
and then within a short period of time we found out just how wet and rusty it was below all its make up
So, we bit our tongues and started our repairs.
everything came out, all the fibre glass lining, carpets and boarding, and all the polystyrene that hid pools of water.



we chipped away any rust and wire brushed everything to bare metal, we used rustins rust remover and gave a good couple of coats of redoxide to all metal surfaces.
we then sealed every gap and frame joint to stop air and moisture from getting in-between the panels and metal frame work, we glued in 25mm sheets of insulation board, again sealing around each board, over the insulation board we added a good thick polythene moisture barrier, before re boarding it all and riveting back the fiber glass ceiling.


put a dividing wall in place with sliding door as the cab was losing all heat.

wood burner was removed and re situated, the guy had only used single flu but assured me it was safe as it had been professionally fitted by his mate who fits them into narrow boats, proved it wasn't safe when the ceiling started to burn and melt. it has now been fitted with twin wall and fire proof mastic up at the ceiling, need to lift it an inch to give air flow below.


have made a seating area thats turns into a good sized bed, have put new kitchen units and worktop in, but just saving now for a 3 way fridge, have refitted the carver water heater and fitted new connectors and pressure valve as they had perished.
Still in the process of building the shower/toilette and have today ordered the new cassette for the thetford C200, the old cassette has parts missing that are now obsolete. have had matching curtains made to replace the cheap wooden blinds, new ceiling carpet and floor carpet, have also put down a rubber floor membrane, then underlay, and then the carpet.
just some more pics, hope you like.
bought a new 135 ah banner bull leisure battery, the guy said it had a leisure battery but it didn't!!! got some spot lights from eBay and have wired them in, along with the carver switch, and pressure switch etc, but still need to run them through a fuse box and connect to the battery, and also install the relay switch.
lots to do but hey ho...




hope all that worked and if so, I hope you like








