Do you need a table?

[FredTransit]

Just acquired a Land Liner camper , but one thing it doesn't have is a table. So off I went to Ikea, and bought two table legs with the screw in bracket plates for £2.50 each. You need to buy two as you only get one plate per leg (so call it a fiver for a camper table leg).

The leg itself has a short threaded rod welded in one end, and a plastic cap with an adjustable foot at the other. I undid the plastic foot, and screwed it through one plate. this made a plate that can be screwed to the table top. I needed to fix some thicker wood to the underside of the top, which I made from one of the bed boards that make up the bed. With the leg unscrewed, it can still be used for the bed as the fitting is underneath.

Then it was just a case of screwing the other plate to the floor, this is the plate the shorter thread screws into. I then just screwed the leg into the plate and hey presto! a removable one leg table for a fiver!! I think it's a bit high, but the plastic foot end screws into a plastic cap, which can be prised off leaving an open tube. This can be shortened.

Pics to follow.....

[Henry's Driver]

Blinding! Await the fotos with bated breath!.....Henry has 2x Desmo Plates in the Floor but legs & F/M spigots did n't come with the vehicle when purchased (...& to think how much I had to pay!!! ) Any way of putting in an Island Table w'out paying mad prices is MUCH appreciated!!

[FredTransit]

Havent uploadf the pics but already l made a mod! Found an 8mm bolt that fits better than the 'foot' and with a small dent carved into the chipboard it fits far more flush to the underside of the table top. It is too tall though, and needs about 2in off the tube