My MK 7 transit

[limitedblack]

Did the injector seals again, took the cam cover off this time to clean the seats too.



Before,



After,




All cleaned, new copper washers, new bolts greased and torqued to the ford specs, with my new sexy digital torque wrench

Fuel filter to do tomorrow too

Do these go often then ?

[Rumble bee]

What did you use to clean down there ??

Paper towel taped to a long screw driver, aka the injector cleaning stick 5000 TM

Do these go often then ?

Did mine again as I didn't take off the cam cover last time to clean off all the gunk, didn't have a torque wrench at the time that went low enough either.

They looked like this first time around,




Chris

[limitedblack]

Yuk

[limitedblack]

What did you use to clean down there ??

Paper towel taped to a long screw driver, aka the injector cleaning stick 5000 TM

Do these go often then ?

Did mine again as I didn't take off the cam cover last time to clean off all the gunk, didn't have a torque wrench at the time that went low enough either.

They looked like this first time around,




Chris

I've got a few tools like that, my best is the cctv8000, consisting of 3meters of 1/2" steel box with a dustpan brush taped on the end, gets the cobwebs off my camera without any need for a ladder

[Rumble bee]

I once duck taped an electric hedge trimmer to a 3 meter length of copper pipe, to trim my grans tree whilst stood on ladders. Didn't go well.......

[Azer van man]

Good to see you've torqued them to Ford spec.....a very good Ford Tech friend of mine religiously Torque sets everything to Ford Spec and has never had any repercussions...Says it all really...

[limitedblack]

:lol:

I once duck taped an electric hedge trimmer to a 3 meter length of copper pipe, to trim my grans tree whilst stood on ladders. Didn't go well.......

28mm I hope

[Azer van man]

:lol:

I once duck taped an electric hedge trimmer to a 3 meter length of copper pipe, to trim my grans tree whilst stood on ladders. Didn't go well.......

........! Your obviously still alive so done well there fella....

[Rumble bee]

:lol:

I once duck taped an electric hedge trimmer to a 3 meter length of copper pipe, to trim my grans tree whilst stood on ladders. Didn't go well.......

........! Your obviously still alive so done well there fella....

Yeah still got most of my fingers and toes too

[Rumble bee]

Dyno'd it, at awesome GTI in Irlam.






155bhp, 303 Ft-lbs of torque. Not bad for a 110.


Chris

[limitedblack]

Damn, quicker than me ATM, postman had been

[foxy transit]

Nice pic on dyno... And impressive figures

Cant wait to get my remap done

[foxy transit]

Also whats happening with the sport arches you bought

[Rumble bee]

Got half of the arches fitted, the two small parts on the front bumper and the two large parts on the rear. Need to pick up some plastic quick clamps to get the front ones on tight. Got them done in yellow in the end

[Rumble bee]

Nice weather so new pics