My mk6 swb

[looneyfitter]

How wide was the side space mate?

[Punto443]

From memory the seats were about 900mm?

[looneyfitter]

Sorry mate I mean the compartment you left on the right hand side looking from the back. The bit where you can slide 8x4's? Sorry to be a pain

[Punto443]

Sorry mate I mean the compartment you left on the right hand side looking from the back. The bit where you can slide 8x4's? Sorry to be a pain

Had about 100mm either side, so probably about 1100?

The wee man slept across the at tm5, so that sounds about right

[Punto443]

Found a pic from the back

[looneyfitter]

Cheers pal. Looks like there's still plenty of room there too.. Guess your like me. Love Hilti too

[looneyfitter]

Is that a 36v skilly on the right? Love mine..

[Punto443]

Nah mate, it's ma sander It's good gear.

[BigMonty]

think the ply needs colour coding matey.

[looneyfitter]

My finish is super perfect without a sander lol

Got mk7 bits to convert mine today. List below. Can you see if I need anything else for me?

Outer wings
Bonnet
Slam panel
Rad
A pillar plastics
Bumper
Bumper bar

Ta laaa

[limitedblack]

Pen lid for hazard lights

[Punto443]

Pen lid for hazard lights

it works, has done for 2 mots and one breakdown

[limitedblack]

Well he did ask

[looneyfitter]

Lost me there lol

[limitedblack]

You will find there is an issue with the hazard light switch, as mk7 is low current switch to BCM, mk6 is high current to lamp unit, hence it will melt if trying to wire to mk6 loom. Using dubious methods Punto mechanically linked the mk7 front assembly to the mk6 switch using the above mentioned part. Not, repeat, not a bodge