Please help, wire diagram mk7 rear door

[Johnler]

Hi guys I no I need a new wire loom for my van, I have had someone trying to get into my 2011 transit van , by cutting the wire loom on the o/s rear door, but I have no time to wait to buy a new one at the moment, I'm working away from home from some time tomorrow and need to try to repair this loom as I just will not have time to wait to order one from ford, as you will no the wires are all black so its not as simple as I thought it might be, can anyone help me by putting a link is the diagram for the rear door loom so I might be able to get it up and running properly
As it stands I can not lock the van as it just bleeps and opens all doors again any help guys thanks

[loot]

Pm me your email and I'll send you 1, will be bone trying to figure out but hopefully the diagram will show you to the connector so not too bad, have you looked at the wires yet? You might be lucky and match them up by length and cuts?

[Johnler]

Many thanks, I can't pm so here you are thanks again John

( thelerigos@btinternet.com)

Cheers

[loot]

Sent

[Johnler]

Thanks I'll let you no when it comes thanks

[Johnler]

Nothing as yet

[loot]

Your email rejected it 3 times, need hotmail or gmail

[Johnler]

Try send me a normal email

[loot]

Didn't work

[loot]

Right look in the diagrams for.liftgate/luggage compartment lid latch.
That is the rear drivers door locking motor/actuator.
You see it has 8 wires and a short way from it is the connector, the pins are numbered on each item and show how the wires are connected, if you look on your actuator you should have numbered pins and also on the connector block, it you follow pin to pin 1 at a time, you should be able to connect it all back together.
Easier said than done i expect, i haven't seen the actuator on the van tho so I'm going on the diagram.

Actuator............................. connector
Central lock pin 2.............. Pin 7
Lock pin 3.......................... pin 2
Double lock pin 4............... pin 8
Reset pin 5......................... pin 1
Pin 6 ground
Set pin 7............................. pin 4
Door closed pin 8............... pin 3
Unlock pin 10..................... pin 8
There's another connector coming off after the connector above that has 5 wires.

[Johnler]

Thanks ill have a look later cheers

[jkchanner]

Pm me your email and I'll send you 1, will be bone trying to figure out but hopefully the diagram will show you to the connector so not too bad, have you looked at the wires yet? You might be lucky and match them up by length and cuts?

Hi, is there any chance you're still active and able to send the wiring diagram to me? I have the same problem, have been trawling for weeks trying to find a diagram but no joy

[loot]

My diagrams are on hard storage but as above it doesn't matter because the wires are all black.

It is a common fault that inside the right door loom the wires can break. So you need to have a look and hotelier find 1 that is kinked , you need to then repair it, it may not have snapped completely through its coating . Above are the pin numbers that you need to find to go from 1 to the other.

You haven't said the symptoms that you are having.