Nox sensor failure

[yann500]

Hi all,

I have P229E DTC on forscan, It seems there is a sensor 2 bank 1 failure.Where is on my ford connect 2019 v408 this sensor ? Thanks in advance '

[metalworker0]

Don't know, as you don't mention engine size

have a look here

This is a sub page of "catcar-info" site detailing all exhaust systems for all connects made after 2013


https://www.catcar.info/ford/?lang=en&l ... A9PTMwOTAz

main entry page for 2013 onwards connect

https://www.catcar.info/ford/?lang=en&l ... A9PTMwOTAz

sometimes sensors are just called sensors on that site...youll have to sometimes put the part number into ebay to workout what type.


all the best.mark

[yann500]

Thanks I will look at, my engine is 1.5l DV5 ecoblue.

[metalworker0]

Ford with their names lol .. naming everything ecoblue

going to put everyone off, as they will all (well me anyway lol) think "wet belt", which yours doesn't have

They confused everyone by naming a lot of other vehicles a few years ago as zetec, that be whether they were diesel or petrol or whatever, when the zetec name became the trim level and not the engine..

all the best.mark

[metalworker0]

can you see a nox sensor there ..i cant ..maybe diagrams are not up to date?

all the best.mark

[metalworker0]

from searches, think ford call it ..I could be very wrong

a nox temperature sensor

does that give you any more clues?

all the best.mark

[metalworker0]

having probed all models in these forums here from google

there is no report of P229E here

i suggest use forscan


NOTE: and use forscan to get correct fault codes with proper explanation of them - your generic fault code reader may be somewhat misleading

Here on this site - They recommend "Forscan" which is FREE software that you download to a laptop..you buy the interface cable
You must join the forscan forum ..again free, to get the software and more answers.

https://forscan.org/forum/


all the best.mark

[yann500]

Hi all,

I confirm that I use forscan and give me DTC P229E sensor 2 bank 1 failure. But I don't know where is it? Thanks

[metalworker0]

no ones answering -- all i can suggest using forscan you start dis-connecting and re-connecting sensors until you get a signal from "sensor 2 bank 1" that says its disconnected. think it may say something like circuit open.

all the best.mark

[yann500]

Hello,

Yes, it's a good idea but it's not easy to disconnect it, these sensors are placed in the body car. I will have to do it.

Thanks.

Yannick.

[yann500]

Hi all,

After disconnected each Nox sensor I found that is malfunctioning. I will try to clean it but I think to have replace it.
Thanks.

[metalworker0]

ok ... please tell everyone which one you found it to be ..2nd down from exhaust manifold etc ..just in case someone comes here and asks the same question ..

all the best.mark

[yann500]

Hello,

Yes of course, I will buy to replace it. I'm looking for the best price for this sensor. I will take and post some photos.

Regards.

[metalworker0]

make sure its got made somewhere in Europe on it, or Japan ..not China


all the best.mark

[yann500]

Sorry for the delay!!!