where to place axle stands ( need to do front brakes)

[G15FTC]

2015 ford tourneo custom lwb fwd

i know where jacking points are but where can i safely place stands?
want the whole front end up,

its stressing me out as just want to crack on and do front brakes.
The rears last weekend were a doddle to do lol

thanks
stressed G

[Airthies]

Anywhere between the two wishbone bolts on the front subframe is fine.
I usually add a small bit of wood between the stand and the subframe since it's a flat surface.



Sent from my Pixel 8a using Tapatalk

[Airthies]

For getting the front hub and disk off have a look at this video.

It's not exactly the same but similar enough to what your doing.

https://youtu.be/D41EsmIsOsQ?si=amRdlXnpEPVHyPca

Sent from my Pixel 8a using Tapatalk

[metalworker0]

from the custom
BEMM

[dumper]

Axle stands are ok but for working at home I prefer wooden blocks I have a cut up railway sleeper that I put underneath the engine crossmember each side of the trolley Jack