zetec

[bez]

dose any one no if the zetec will bolt to a pinto addapter plate? also any one got size of zetec flywheels.got my other zetec turbo sat here and dont think it will take much doing.

[Luke]

i dont see why the zetec wont bolt to a pinto adapter, the only problems i can see are the flywheel and starter. i was considering this and the way i was thinking was to redrilla transit pinto flywheel to fit the zetec crank and if it needed a spacer (not sure on that bit) then space it back to fit the starter or if it was too far, ie the zetec crank is longer then mabe pack the starter back
i never got any further than thinking about it but by going that route you can use all standard transit stuff

and then you have the relocation of the thermostat water rail bit but thats standard escort stuff been done a million times before

[bez]

thats what iv been thinking mondeo 2l flywheel may be used as its close in size to the pinto one.
i think engine mounts will need to be one off,s.

[Luke]

yeah i cant see engine mounts being much of a problem

anyway have you got any pics of the van with the 24v cossy in it yet

[bez]

iv not taken any yet too busy driving it.ill get some in the day tomorrow.

[Luke]

i need to know what it loosk like incase i see you about

are you gonna bring it to north weald this year http://www.fordtransit.org/forum/viewto ... 12&t=40550

[bez]

i should be there.
mines a white minibus with black windows,says bez on number plate.some times seen going side ways.

[MinorMatt]

Got 2 1.8s in the shed, one will go into a moggy minor and I will flog the other on.

I believe most 1.8 and 2.0 bits are the same, would you like me to take some measurements of the flywheel at the weekend?

Matt

[Luke]

i should be there.
mines a white minibus with black windows,says bez on number plate.some times seen going side ways.

i take it it was you behind magna last week someone thought it was me

[bez]

ye it was needed some where to set my amps up.any info on the zetec stuff will be nice.

[MinorMatt]

Give me a list of what you need to know, I will measure as much as I can next week and take pics of what you need to see

[mad matt]

l know that the the zetec will bolt on to a pinto box as they use the zetec motors in a lot ov kit cars

matt

[bez]

nice one