My MK3 cosworth

[MarkM]

I appreciate that in most case pictures posted up are meant for ego massaging, well sorry previous comments about the roof bar are valid in my mind and good luck with the mini spots on the bullbar as they are going to get hit/damaged, the cosmetic treatment of the wheels etc IS good and the inside is looking more like the Enterprise everyday..I didn't comment on the clocks before but sure working is nice but the mounting suround really needs to be looked at. Better to replace the dash with a MK5 but then you would lose the amby pod. I would also look to moving the extra dials to the A pillar but again that is just me. I have a spare A pillar cover so when I get some time I will take that into Halfords or similar and look at the different Dial pod holders to see which make (car model) will fit the best as obviously one isn't made for a Transit pillar intentionally.

[rover]

The rrof rack will be off soon and there will be a nice stainless bar holding the lights. i am on the look out for a full width stobe light bar to put over the back doors

Thats what im saving me pennys for but i keep seeing things that would look good on it and im back where i started

Its crying out for a set of alloys too

Rover.

[Guy88]

i Have a plan for the clock surround.

Im getting some stainless for the roof lights next week

[Guy88]

Time for a quick update. Got to do the chassis welding as i got to put a trailer on it soon.

I will do the arches at the same time.

I have now decided not to do a V6 cossy. i may be the proud ovner of a MOT failure sierra cosworth so i am thinking of fitting a yb cosworth. am i right in thinking it would fit with a pinto adapter plate

[Luke]

am i right in thinking it would fit with a pinto adapter plate

yep same block as a pinto - you will need a transit pinto flywheel tho - to mate with the starter - and i assume that will mount to the cossy crank

how much you paying for the sierra

[100ps_drw_hicube]

trailer??

you realise you cant tow just thought i'd point that out before some others do

but it hasnt stopped me

[MrMPuk]

Time for a quick update. Got to do the chassis welding as i got to put a trailer on it soon.

I will do the arches at the same time.

I have now decided not to do a V6 cossy. i may be the proud ovner of a MOT failure sierra cosworth so i am thinking of fitting a yb cosworth. am i right in thinking it would fit with a pinto adapter plate

The YB engine will kill the MT75 quite quickly!

[Guy88]

am i right in thinking it would fit with a pinto adapter plate

yep same block as a pinto - you will need a transit pinto flywheel tho - to mate with the starter - and i assume that will mount to the cossy crank

how much you paying for the sierra

I have got all the pinto bits allready fitted to the van

I coud pollibly be getting it for under £450

[100ps_drw_hicube]

The YB engine will will the MT75 quite quickly!

[rover]

The YB engine will will the MT75 quite quickly!

Kill?

Rover.

[MrMPuk]

I had already edited it!

[100ps_drw_hicube]

should have guessed it im too tired

[Luke]

The YB engine will kill the MT75 quite quickly!

why is yours dead

[MrMPuk]

I've not got MT75 box!

[Luke]

I've not got MT75 box!

thought you did T5 then
I'd have thought the MT75 wouldn't be that bad anyway